Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


Vic

Member
  • Posts

    4
  • Joined

  • Last visited

About Vic

Profile information

  • Country
    Australia
  • Gateway/s
    Home Center 2

Vic's Achievements

Newbie

Newbie (1/8)

0

Reputation

  1. HI All, Hs anyone worked out how to display a variable to iPad app( so that the variable shows on the display) Ideally I would would like to show a variable being on/off so I can see if the variable has changed on iPad or Iphone app. Any information would be greatly appreciated.... thanks
  2. Hi What I want to do is to show from a variable to a ipad fibre display - for example i have setup a variable that changes on a scene called Alarm at Home - I want to display this as a on or off state some how on the iPad in fibre display so that you can see if the alarm in home mode is on or off (active or not active) Just need a simple way to show the state of a variable visually - have tried doing it through a virtual device with no luck.... any help would be greatly appreciated..
  3. HI Has anyone down a rule to turn the alarm on via remote control - for example using a remote control to say a Z wave binary sensor that turns the alarm on to arm away etc to save going into app when you leave the house ?
  4. 1. On the alarm panel- we have a remote control that is wired to a fiabro binary sensor that we wish to use to turn the alarm on and off (armed and disarmed) Remote control is in car and on arrival I want to turn the alarm off / on when arriving / leaving without having to go to the fibaro system to do this. In the rule creator I can not find a way to do this? I can see the binary sensor tun on and off but can not in scene editor associate this to the alarm to turn on and off the alarm in fibaro HC2 Can anyone help on this thanks
×
×
  • Create New...