PAL_HC2

Since my posting I have given up the usage of the IR-controlled contactor and applied a classic contactor that is controlled by a Fibaro relay module. BUT, the problem does not end there as there are no commands in the scene scripting (by graphical elements) that can control the power usage. I am at this stage rather pissed by the "compatability" between modules on Z-Wave. If someone has experience from this unit in LUA I would love to get enligthened!

The Qubino 3-Phase Smart Meter can operate an external contactor if certains parameters are set - this is a very smart solution for controlling that you can cut power in case of to high current (power) consumption. BUT, The setup method described is based on settng certain parameters in the Smart Meter while included (no 7=3 and no 100=11), then exclude the unit and when included again it will be noticed that there is an output activiated. The problem is that HC2 over writes alla parameters to default while including the unit making the idea off Smart Meter useless Advicew please

I have an HC2 that is running latest version (official) of SW 4.560. After that the mains was cut to the whole house the HC2 does not reboot and start operate. All LEDs flshing from right to left. After several attemts to toogle the power button on the HC2 it finally restarted properly. It is a serious problem if the HC2 does not restart after a power cut in the house Advice please

Thanks Jakub for helping me find this thread.... Is there any documentation available so I can understand if this is useful or not and how it is directly related to scenes. - I currently use the normal digital inputs to control scenes as a "triggering device" I know that documentation not really is Fibaros strong side of life

I have 3 Fibaro Universal Binary Sensors (FUBS) inside outdoor PIR's. They do their work most of the time but once in a while they "freeze" in breach mode. This is seen as the device panel in HC2 displays a "red man in motion" instead of the steady man. If a scene is based on the FUBS it will run all the time. The only way I have found to resolve the situation is to do a "soft reconfigure device" Problem 1 1a - why does a "freeze" happen? 1b-is there any other way to solve the situation? Problem 2 When I did this some days ago I found some strange things, the device was suddenly excluded from the polling que (stated in the device interface) and there was some new unassigned devices each belonging to the FUBS!! This device is displayed as a remote controller!?!? 2a - why was the device excluded from global polling que? 2b - what the heck is the new sub devices displyed as a remote controller? Running HC2 with 4.13 and the FUBS have updated firm ware.