Anders Hauge

When I go into eventlog in HC2 nothing has happened for the first tries. I press once, and wait 3-5 seconds. Nothing. Press once again, wait, nothing. And again. Then I pressed four times to "wake up", and that is the first event registered in HC2. That is registered as "four presses" and runs scene accordingly. So I feel that if I could manage to set a wake-up interval, mabe the problem should be solved. I will look into if it works to look up the master device, and set wake-up there. Update: I found the master devices as you said @jakub.jezek, by manipulating the URL with ButtonID-1. There I was able so set and save a wake-up interval. I have set it to 7200 (2 hrs) on all my three buttons and will report back how it goes. Thanks!! Regards, Anders

Hi! I am using newest version of HC2 and have set up some buttons to control lights. But I'm experiencing that if the buttons have not been used for a while (like 2-3 hours and up), they don't respond. I have "lights on" programmed for 1-click, but I have to press "1-click" 4-5 times before it eventually reacts. When the button is alive and working, it's stable and works at once every time. Then, after being away for some hours, it's the same again. This goes for all my three buttons installed. I have tried to set an "Wake up interval" in HC2, but that also seems to be buggy. I set it to 7200s (2 hours) and hit save, then the value changes back to 0. So it seems impossible to save and activate a "Wake up interval". I have several more that I was supposed to mount, but I need to have this sorted before I implement more buttons... Any help or tips will be greatly appretiated!! Regards, Anders

I have the same "problem", but it seems there is not possible to use these devices without programming a VD. I'm not a programmer, but after a lot of tinkering, I got a VD to start and stop different activities from the hub. But I cannot figure out how to get the status of a activity to show on a "label" in a VD? Anyone have a working screenshot? Anders