Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
PerryV
-
Posts
7 -
Joined
-
Last visited
About PerryV
PerryV's Achievements
Newbie (1/8)
0
Reputation
-
I have the same problem. In my about 30 node network, I see multiple reports every second. I guess this is why my HCL is responding very slow. Anybody with a solution?
-
Ok, clear. Next available free time, I will try the modern approach.
-
Thx a lot, I was confused by the mentioning of association groups, but I want to use the webpage scene definitions. It looks like you need to use attributes, which is different from the dimmer-2 function (=easier). I have to check if using attributes are possible with the HCL, since I need to be able to detect 1-click (lamps on) and 2 -clicks (lamps off).
-
Do you have practical experience with this using a Fibaro Home Center Lite? What scene codes does it send and which parameters do I need to change?
-
I did use a bypass yesterday. The only thing is how to fit everything using a 50mm (=maximum available depth) of wall installation box : momentary switch, dimmer 2, bypass and a wire connector ... Just want to create a scene id transmitter on an existing location
-
Yesterday I did remove and add the device again to force a factory reset. After this I changed the parameter to activate scene id sending. Everything works fine now. Thanks for the support. Killing the device with no load attached, seems to me like a design flaw. Very happy so far
-
Just starting with Fibaro domotica and built a test board with several lights, dimmers and switches. Needed a trigger to start a scene, so used Dimmer 2 and a switch in 3 wire mode. However forgot to attach a load, as mentioned in the manual ;-(. Since then I'm not able to switch on the lights anymore by dimmer output. The red light on the Fibaro module is red, it reacts to reconfiguring by webinterface and by menu options with the B-switch. Did I damage the output, or do I need to check all the parameters, since calibration failed? I try to recalibrate, but it doesn't seems to work. Thanks in advance.