kickonhigh

If in HC2 <> HC2 connection one node goes down, if this working one will take over controll of all devices ?

hello, I have an issue or maybe it is just lack of knowledge , so please let me know . In one section I have two rooms ( section called first floor, rooms called room1 and room2 ) and one source heating connected to wall plug ( an electric heater) . So I create linked device for room 1 - temperature sensor + wall plug room2 - temperature sensor2 + wall plug and also created zones in heating panel , one for each room with other configuration of temperature, and first room is ok but when second room start heating but only for a while becasue temperature in room1 is reached ... please support some how or give some hints And another question regarding fibaro thermostatic head , I have it with temperature sensor , when I set manually radiator on blue (16 C ) and when temperature on sensor is reaching higher than 16 C , shouldn't it close valve ?

many thanks for clarification , I don't want override scenes, which rely on temp. sensors, by this thermostat so i will choose second option

thank you for support, could you please look at the picture and see if is it correct connection ? does it matter if I connect red cables to IN or Q1

it's 230 V , model of thermostat Euroster 2006 tx , and brand of boiler heating - Junkers

hello for sure it should have capabilities of mjpg streaming , and about compatible most of cameras you can see on plugins page on HC2 , but of course you can add any of ip camera by adding by ip address, in section "Add device", and providing paths to mjpg,jpg etc. some manuals http://manuals.fibaro.com/knowledge-base-browse/connecting-ip-camera-to-fibaro-system/ I have one camera which I can watch online by ID fibaro all the time and it alerting me and sending picture on mail when door sensor is breached

hello, could someone help or give some hints how to connect relay switch instead main room thermostat which was connected by this four cables as on screen below , I want to be able to send to CO boiler signal to start heat or stop heat , is this possible ? of course there are TRV on radiators to control flow . btw. what kind of signal is send to boiler ? or is it just a open/close circuit ?

many thanks for fast support @I.Srodka , I tried this parameters earlier but in the end turned out that bulb was not to able dim but on the packages there was icon with capability of dim ... and reseller exchanged faulty one. @10der - nothing worth ...

There is no possibility to dim bulb I can only switches on and off, during calibration I can see that dimming works correctly. I tried resetting the device etc. Any suggestions will be appreciated