Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


JogiL

Member
  • Posts

    3
  • Joined

  • Last visited

About JogiL

Profile information

  • Country
    Germany
  • Gateway/s
    Other / Inne

JogiL's Achievements

Newbie

Newbie (1/8)

0

Reputation

  1. @Reinhold Thank you for your help! Regarding the calibration: The manual says "The procedure consists of an automatic, full movement between the limit switches (up, down, and up again). [...] Each time the calibration requires the completion of a full cycle (up and down). You are saying that it "must first going down and then up". Maybe it is a misunderstanding? I closed the roller shutter first and started the calibration then (so that it can go up first (according to the manual: "up, down, and up again)"). Is that wrong? I have exchanged the up and down wires already, but that didn't help. @TRicky Thank you for your help!The motor is already calibrated (I have been using it for years without Fibaro). So this shouldn't be the problem. And it is not the motor that is humming, it is the Fibaro (only when the LED is green). Do you think that this is a problem?
  2. Hi, I can’t calibrate my roller shutter (FGR-222, I guess due to missing feedback from the motor; when I started the calibration process it moved for 1 sec. up , 1 sec. down and then ist stopped). After reading a lot of posts in different forums, I'm still not sure if I'm understanding it correctly. Maybe you can help my by answering some questions: Can I operate it (only open and close) without calibration? If yes, is it correct to set all parameters to 0 except #22 (motor operation time) to 25 (for 25 sec. that the rollers need to open/close)? If no, can I make the calibration work by setting the parameters differently, maybe like this: #10 Roller Shutter operating modes: 1 – Roller Blind Mode, with positioning #18. Motor operation detection: 3 (this W number is shown on the tile when operating)? What does the LED mean? Is it Ok that they are still green or read after the movement has stopped? When the LED is green the device is kind of humming silently. Is this OK? Regards, Jochen
  3. Hi, Unfortunately I can't help you, but maybe you can help me? I can't calibrate my roller shutters too. Can you explain my how you did it "without positioning"? I've set the parameters as follows: #10 Roller Shutter operating modes: 0 – Roller Blind Mode, without positioning #22 Motor operation time: 25 (for 25 sec. that the motor needs to open respectively close). All others are 0. Would you recommend something else? Regards, Jogi
×
×
  • Create New...