Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


Guest Message by DevFuse

Edwin1972

Member
 View Profile  See their activity

  • Posts

    3

  • Joined

  • Last visited

About Edwin1972

  • Birthday 05/09/1972

Profile information

  • Gender
    Male
  • Country
    Belgium
  • Gateway/s
    Home Center 2

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Edwin1972's Achievements

Newbie

Newbie (1/8)

0

Reputation

  1. Edwin1972
    Hallo en Welkom op het forum
  2. Edwin1972
    Hi guys, I use two of these boards aswel, in combination with the VD above. Now, however, I would like to see the state of the relay in the VD. Is it possible to read out the status of the relay? I think it should be possible because in the app (from robot-electronics) it shows if the relay is on or off. Once I know how, I can adapt the VD accordingly.
  3. Edwin1972
    Great script. Works like a charm. And finally a very good explination about wake up and polling.
  4. Edwin1972
    Thank you for this possible solution. This is an option if all the valves were z-wave enabled. However to reduce the cost and the lack of coverage in the basement, I use 3 ethernet relay boards (Robot Electronics ETH-008) (total of 24 relays) wich I control through a virtual device (accessible with a scene). Therefore I need to use a scene or other VD that can compare the values of my sensors with the heating panel. I think.
  5. Edwin1972
    Hi Guys, I am looking for a way to compare the values of a room's temperature sensor to the desired temperature in the heating panel of that room. Because my house has many rooms, I have no thermotats just fibaro motion sensors in every room wich can tell me the temperature. Each radiatorvalve is controled by an relay. There are 2 pump groups for 4 zones. I created a heating panel but that can only control thermostats. I would like create something that, for a given time, compares the actual room temperature too the set room temperature in the heating panel. That way I can controle the valves and pump relays accordingly. Is there a way to find/call the values of a specific room in a heating panel from within a scene or virtual device? Many thanks
×
×
  • Create New...