Wiers

Hi 10der, I like to use your VD because the VD from the french forum is eating to much CPU. But I do not get yours running. I keep getting the same fault in the debug, see above screenshot. Can you help me out? Thanks Eric

Hi, Tried to use your VD with looks great but I am unable to get it running. Keep getting the error message: And even without changing the mac addresses to my own mac addresses of my phones it shows that they are present. Any idea? Thanks Eric

Fibaro Software problem. Fixed it by returning to previous software version. Eric

Hi, I have a question about a virtual device which I already have been using for a year. It is for an ambilight which I made for my TV and have been using together with KODI. The software is Hyperion and you can also command it from an app. This week disconnected the raspberry Pi where Hyperion is running and when I connected it again it got another IP adres. So I tried to change the IP adres in the VD but when I try to save it I get this message "Unable to create button - selected ID already exists." I did not change anything except the IP adres. Even when I put back the old IP adres I get the same massage. Anyone got a solution? Thanks Eric

Got a few emails for high CPU load. Did a reset hand load went back to normal. Would be nice if it did a automatic restart after for instance 3 high CPU loss within 1 hour. Eric

Hi Cag014, Found your Scene already and installed it. It is running now and hopefully gives me some clues. I also gonna try the CPU RAM monitor Scene. Thanks,keep you informed. Eric

Hi, After a couple of months running smooth my HC2 freezes up about 2 times a week. I tried the upgrade 4.503 and still got the same problems. The only thing I can see is after a reset the RAM use is normal (25%) . Once I saw the ram at 99% and did a reset and it went down to 25%. Because i cannot acces my HC2 anymore after a freeze I don't know what causes it. Is there a way to figure it out afterwards? Is there any log or something what shows what could be the problem? I only have about 20 devices and 10 scenes. thanks Eric

I have the FGWPF-102. Running it manually is no problem. And it is not actually switching on and off, it is only the signal. Almost sure it is out of range and since moving the pool is out of the question, I have to find another solution

The VD is working, However.... when I connect it to my PoolPump it switches on and direct to off. When I connect it to a light or other switch it works great. I think the problem is that most of the time I have a communication problem with the FGWP102 switch. And after some searching on the forum I am not the only one. Also it is the switch furthest away from the HC2 and connected via repeater. So it is moving the pool or buying a second controller . Thanks for the help gentleman. Eric

It starts OK and the countdown goes to 119 mins but keeps hangin on the 119 mins. Eric

It did not countdown So the pump kept running after the 2 hours. Eric

Alright, that makes sense. The reason I asked is that the timer in the display keeps hanging on 119 mins. I guess I will find out after 2 hours if the pump stops running. rgrds Eric

one question. at "local timer" you have 7200000 seconds? Should that not be 7200 seconds for 2 hours? Eric

spazpeker, you are my hero Just what I was looking for, thanks. Rgards Eric

Hi Jakub, I have the FGWPF-102. I have one scene to have it running from 01:00hr lt to 05:00hr lt. Now I am looking at using a VD with a status change, and a scene which looks at that status. So if the status is 1 then turn on pump and turn it of after 7200 seconds. It seems to work but I think there must be an easy way which I am overlookingRegards Eric