Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


ggrizliv

Member
  • Posts

    69
  • Joined

  • Last visited

About ggrizliv

  • Birthday May 17

Profile information

  • Country
    Slovenia, EU
  • Gateway/s
    Home Cennter Lite

Recent Profile Visitors

248 profile views

ggrizliv's Achievements

Learner

Learner (2/8)

4

Reputation

1

Community Answers

  1. Fibaro, what's going on with you? HC3 Lite?!? Why you realise such limited hub? Come on.. HC lite for small installation, ok, but HC3 lite? 1 MJPG cam? Only 20 scenes? come on! This hub is totaly doomed to failure. Why you not just update and support what you promise on HC3 on start? You were best until 2016, but now you lost on all line to competitors.... sad... i'm very disappointed and i'm not alone...
  2. I have the same problem every single time... Windows are always open when i change batt, but still low battery.... when i delete device and add again, then is ok... Damn...
  3. How much power has boiler heater (W) ? 2000W, then you can directly connect wires to boiler, if your boiler heater has more power you need some standard relay between boiler and fibaro relay (fibaro relay turn on standard relay, and reley switch boiler heater on)...
  4. or you can use some 24V DIN relays (if u have space in fusebox) to switch high voltage (230V) to keep your existing installation... but still, better is to replace all wirring from switches if u can...
  5. If you use momentary switches there is no problem with this wirring. Problem with this wirring is if you use toggle switches, because you have only two wires and you need 3 like in my case. So, i have replace my toggle and intermediate switches to momentary switches and now work great. just follow vesternet diagram wirring...
  6. Yes, battery is so quick empty, I use one old usb charger to power multisensor and work just fine...
  7. Check this wire diagram. For toggle wire system you need only 1st and last (toogle switch) w/o intermediate switch (kitcher and living room). With intermediate switches (in your example - you need only one intermediate switch with two toggle switches) adding to your dinning room...
  8. I was tested Wanscam HW0022 IP cam (fullHD cam) with Fibaro Home Center Lite and this camera work just fine on HC. Here is setting: Camera model: Other model User: <Cam Username> Password: <Cam Password> IP address: <CAMIPADDRESS:PORT> JPG Path: tmpfs/auto.jpg
  9. you can place the Fibaro switch inside the momentary switch or in the gate control unit. it's your choice....
  10. When you change batteries, you must open door-window, replace battery, and then close door-window.... if you don't do so, you do reset to your sensor and then you must add as new device to work again....
×
×
  • Create New...