Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
Ronald Arissen 0
I have 10 danfoss LC13 that I can't get to work properly.
I have 3 sections Living, Bedrooms and Bathroom.
To each section or zone I have add a few rooms with a LC13, and did make a zone into the heating panel.
When I say Living must be 21 degrees, than the 3 LC13 must go open en heat up the room until 21 degrees I guess.
But it looks like, that one doing fine, one stay's off and one go's totally open en is trying to heat the compleet room.
Also some times one of the 10 LC13 is opend spontaneously. And that's not for 5 min, but for hours.
When I then look into the Fibaro system at my hardware I see that that LC13 is not opend but on the temperture institution that It must be according the schedule.
Connection is okay, not out of reach and no error messages.
Is the HC2 V4.035 fully supporting the LC13 ?
Because I have no template to addept or see the parameters.
Hope that one of you guys have some experience with the LC13 and can help me.
Link to comment
Share on other sites
15 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.