Search the Community
Showing results for tags 'modules'.
Many thousands of Fibaro devices have been bought by non HCX users yet there is no way to update the devices to the latest firmware to fix bugs in the purchased products. The feature is advertised as a feature of the product and part of the certification but is not available to the majority of purchasers. Please could Fibaro provide a way to deliver firmware to modules that does not require a Fibaro controller.
Imagine you have set up a house with hundred modules and one HC2 over the last year. About two third of your modules are clued/sticked to their place (like most of the door/window sensors that are available). To exclude/include them to your controller they must be in direct close range to it. So you will have to remove them from their place by destroying the clue most likely. Is there any better and easier way to reinclude these devices without buying 100m power cable and 100m network cable moving the HC2 controller from module to module? Is it possible to use anot
Hi everyone I want to start a complaint about the Qubino flush relay's still not supported by Fibaro. Still templates are not available for these modules. I do not know why Fibaro still are not supporting these modules but to my opninion they should starting supporting these by now. Especially keeping in mind all other brands are supported much better. I did sent templates to Fibaro several times. A lot of customer have these units, probably because they support energy metering. So Fibaro, what's goinig on here? Please reply so we have as many as qustumers possible to put some pressure i
hi guys, yesterday I wanted to upgrad from 4.080 to 4.082. After the upgrade finished, I had only 5 devices left of my previous 43 devices. I tried to load the backup, that was automatically created. Same result 5 devices only. I then went back to 4.080 with recovery mode. Loaded the backup and again 5 devices only. If I go back further, where I had 31 devices only, everything is restored as expected. But ofcourse not all devices are there then. When the restore of the 43 devices Backup finishes, i can see breefly a message telling somithing like: finished removing dead dev