Welcome to Smart Home Forum by FIBARO
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Smart Home Forum by FIBARO Team
Search the Community
Showing results for tags 'add device'.
Found 5 results
Hiding "+ Add Device" on Dashboard
Corceiro posted a question in Home Center 3
Adding Z-wave device
josjg posted a question in Home Center 3Hello, Today I received my brand new HC3 to replace my Homey Pro that has terrible z-wave performance. I unpacked and installed according to the setup steps. Software updated to 5.021.38. I excluded a Qubino Flush Dimmer from Homey and tried to add the device to HC3. The console shows HC3 going into learning mode but adding the Qubino (3 x switching) failed. Factory reset the Qubino and tried again with auto-inclusion and then again "normal" inclusion. No joy. Unpacked a brand new Fibaro Dimmer 2 and tried to add the device. Again, HC3 goes into learning mode but device is not added... HC3 shows nothing being wrong, Z-wave diagnostic show green "fully configured", also after I did a z-wave network reset. Z-wave version 4.33. Can anyone show this (still) inexperienced Home Center owner the way to a solution? Many thanks,
The inclusion process
knuth posted a question in Home Center 2After configuring a new house using the HC2, I have a few frustrations related to the inclusion process for new devices (Add Device): When assigning a device to a room, it would be nice to be able to assign the main device only, and have all the sub-devices/slaves follow. Having to do the room assignment on each one is time consuming (in one of my cases, a Z-TRM2 thermostat, there are 11 sub-devices per unit!). Is there a smarter way? When I check "NWI" in the Add Device panel, or make any other change to the three inclusion options, the "Save warning" (an exclamation mark) appears to the right. The save button does nothing, however, and there is no other save possibility. When inclusion is complete, any attempt to exit gives a warning that a "save" is missing and that data may be lost. I think there is a bug in this particular panel. Either the warning is unneeded, or the save button should be activated to store the choice of options. Have I missed something? Why is there a button in the Advanced section to "download template", when there is no way to install what I download? I know the procedure is to forward the template to Fibaro Support (and keep expectations low for any follow-up), but it seems strange to handle this inside the configuration panel when the template cannot be configured by the user.
hc2 has stopped being able to add devices
Guest posted a question in Home Center 2it seems that my hc2 has stopped being able to add devices, what could be wrong. I have reset both my hc2 and my devices
Newly added devices always set with "Device excluded from polling" option
speedy posted a question in Home Center 2Hello everyone. Everytime i add a device (fibaro device or other, it doesn't matter) its always added with the option "Device excluded from polling" option. Have tried this with 2 HC2 and the result is the same. I can't see a situation where it is preferred to have this as a default option. Is this a bug or is it intentional behavior? If it is intentional behaviour Fibaro please change it back to always add devices so that they are included in the global polling queue. Unless I'm missing something?