Welcome to Smart Home Forum by FIBARO
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Smart Home Forum by FIBARO Team
Search the Community
Showing results for tags 'adjust'.
Found 3 results
Problem description: Cannot control or adjust the room temperature with the Danfoss Z-Wave RS Room Sensor. The settings in the radiator thermostat are not updated (no change). System setup: Danfoss Living connect Z radiator thermostat (014G0013) is installed in the living room. Temperature is controlled by the Home Center Light (4.061 Beta) via Heating panel and schedule heating programs. Works alright. Manual adjustment directly on the radiator thermostat and via HCL (Devices) is also working fine. All is good. I have bought new Danfoss Z-Wave RS Room Sensor (014G0160) and would like to adjust the living room temperature with it. Device is installed and shown in the living room. Manual adjustment via buttons (up / down) of the room sensor is shown in the HCL interface. However the settings from the Room Sensor are not taken over by the radiator thermostat. No update. The room sensor is not linked to the radiator thermostat. The radiator thermostat does not care about the room sensor settings. Configuration Room Sensor: Parameter 6 Set-point control function: Enabled Parameter 7 Temporarily override scheduler: Enabled Parameter 8 Set-point type in Thermostat_Setpoint_Reports: Heating What is wrong? How can I use the Room Sensor to temporarily manually adjust the room temperature?
Hello, I'm installing some Fibaro Roller Shutter modules with Somfy Sonesse 40 motors and some of them stops before, some other stops after the end. I could fix by changing the motor position but I was wondering if there is a way to tell the blind where to start and where to stop... Any help? Dem