Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'dc'.
Hello, Instead of switching a resistive load, like switching a lamp on or off, I would like to use the Single Switch (FGBHS-213) to generate, via Apple's Homekit, a 5V DC signal (HIGH/LOW), e.g. to interface it with a momentary push button operating at this low DC voltage or to generate a signal for a microcontroller. Therefore, instead of sending out via the Q terminal the 230V AC, I would like to switch via the relay in the FGBHS-213 a 5V signal. Is this at all possible? Or does the unit by default output on Q only the mains 230V AC that is fed into L? In other words, can I use the L and Q terminals of the relay and connect them with 5V/GND of a DC circuit instead? Thanks for you advice.
Hi, Anybody has experience with the Qubino Flush 1D relay(ZMNHND1) running from 24-30VDC? I tried to include it without sucess, but when I connect it to 230VAC it includes in the system and works, but when I try to run it from 26VDC it doesn't. From the same power source a Fibaro Universal Binary Sensor is running without any problems. Thanks, Marton