Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'dimm'.
Hi, I described my issue already in a topic about bypass/dimmer compatibility but I believe it requires a new topic. Scenario: - 2 x Dimmable GU10 Philips Master LEDs 5 W each on the circuit (around 11W in tottal according to dimmer measurement) - 3 wires configuration with Dimmer 2 and bypass 2 presented below - monostable single switch - bulbs calibrated after first start up - tried with 2 completely new dimmers and behavior is the same Behavior: 1. Momentary push of the switch turns the bulbs ON or OFF with no issues 2. Light is ON. Now, pressing it for a longer time doesn't do anything - no dimm is observed. Once switch is released, then it goes slowely to the lowest level of dimm. Since that time, momentary push makes it goes always to full brightness (ON) or to lowest dimm level again. The only way to make it works on and off is to double click the switch. 3. When I try to set whatever level of brightness in the HC2 it works perfectly. Same with on/off. I tried to remove DImmer unit but it works the same. Bypass and dimmers have been of the shelve, sealed boxes. Any ideas? Thanks
Jeśli szukacie produktów które na pewno działają z Dimmerem lub RGBW zapraszam do kontaktu. Zajmujemy się oświetleniem od 1996r. , prowadzimy salon Fibaro od 2011r. Produkujemy oświetlenie led. [email protected] www.ledbest.eu PRODUKTY TOP taśma led 18W 24V 2800lm=1m https://www.ledbest.eu/pl/p/Tasma-led-ciepla-De-Luxe-rolka-10m-18W-2730lmm/9606 taśma RGBW 16W 24V https://www.ledbest.eu/pl/p/Tasma-led-Regular-300-led-rolka-5m-24V-RGB-cieply/9825