Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'eedomus'.
Hello everyone, I just got in my new flat and decided to set-up my domotic apparatus starting from a Yubii Home hub. No issues with dimmers, door/window and smoke sensors. The problem is that my flat was pre-equipped with Somfy RTS shutters and a Danfoss Ally radiator hub (Zigbee protocol), which unfortuantely are not comatible with the Z-Wave protocol. I have been looking around to understand what could be the easiest course of action to controll all devices from my Yubii Home box. From my understanding, either a Jeedom or an Eedomus hub, along with a RFXCom module, should do the trick for both the shutters (hence the RFXCom module) and the radiator hub. As I'm not an expert however, I was hoping that someone here could either confirm the above makes sense or propose an alternative course of action. Thank you in advance for your help!
Hi, To start with I'm using the eedomus box and not the <fibaro Box and swing shutters instead of Roller shutters/ I've been struggling with partial positioning of my FGRm-222 for a long time and have decided to give up and use parameter 22 motor operation time. I'd like to add that calibration cycle is working fine . Following a successful calibration cycle (Parameter 29 set to 1) Open-close-open when I ask for a 50% or 1% it would simply open or close BUT would show Partially open or close at 90%!! Now questions ! 1/ am I right thinking If i want to partially open I should simply put 50% (or less) the value and it should work or should I try something else? 2/ How to proceed with finding a solution to this problem * any other parameters I should use to get the expected result ? 3/ Big question : is working with the latest Roller shutter V3 ??? Please help me . Thanks
Hi, I have several Fibaro Motion sensor (FGMS-001 ZW5 v3.2) integrated with my eedomus zwave controller. Most of them are working fine, but one of them did stop working and now is not reporting any information to the controller: motion, vibration, temperature and luminosity. I have reset the device (follwing the user manual instructions), excluded it and included it back into the controller, and the situation remains the same. The device responds and executes correctly any of the zwave commands sent from the controller (get and set wake_up_time, configuration_set of any parameter), but as I explained the device does not send any information to the controller. Any suggestions on how to proceed ? Should I get the device replaced ? BR