Hello,
I got my HCL and one FGR222 module (roller shutter 2) last week. I did HCL basic setup easily (general setting and rooms creation) but I didn't success to include my FGR222 module.
So here is what I've done and the result I got :
- I set HCL to learn mode from the interface (by clicking "add" button into "add/remove device panel) - I connected the power supply on FGR222 - On HCL interface, I saw a log meaning inclusion is in progress. Here is the log (sorry it's in French)
[22:57:15] Home Center en mode apprentissage [22:57:23] Module ajouté [22:57:24] Ajout du protocole des noeuds terminé [22:57:24] Ajout des modules terminé [22:57:24] Ajout des modules terminé [22:57:31] ID 6: Received association report from group 3 [22:57:32] ID 6: Received association report from group 3 [22:57:32] ID 6: Set association for group 1 [22:57:33] ID 6: Received association report from group 1 [22:57:33] ID 6: Set association for group 2 [22:57:33] ID 6: Received association report from group 2 [22:57:34] ID 6: Set association for group 3 [22:57:34] ID 6: Received association report from group 3 [22:57:35] ID 6: Set association for group 1 [22:57:35] ID 6: Received association report from group 1 [22:57:36] ID 6: Set association for group 2 [22:57:36] ID 6: Received association report from group 2 [22:57:36] ID 6: Set association for group 3 [22:57:37] ID 6: Received association report from group 3
- I wait few minutes but as nothing happened, I clicked on "close" button - Then I got again turning balls I let it turned more than 15 minutes and it still the same. So I reboot HCL by pushing power button. After reboot completed (3 leds on) I tried to connect to HCL and I got error 503 (server unavailable). I had to use factory reset option to get it working back. I made this operation about 10 times and always the same. Between my HCL and FGR222 there is less than 1 meter and I tried this operation by using automatic or manual inclusion but the result is always the same. At each time, I must reset FGR222 memory to get inclusion "working".
After looking on internet, I saw during normal inclusion that some parameters must be received by HCL from module but not in my case.
So please, could you tell me what's wrong?
P.S : the z-wave led is never on on my HCL, even during inclusion, is that normal?
Thanks in advance.