Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'fgr221'.
I've just upgraded from HCL to HC3 and added the first of 14 FGR221 roller shutters controllers (FGR221 firmware and HC3 Beta firmware are both up to date). However, After adding the shutter device, it will not move up or down via the app (parameter updated in settings to single momentary S1). I have poisitioning normally set to on, but even with it off, nothing happens. I have manually controlled via S1 the shutter up to 3 cycles to ensure it is calibrated but still no joy! I added the shutter device back to the HCL and everything works fine. Am I missing something here? The HCL is unstable and it needs to be reset every 4 days so I need a more stable working solution with the HC3.
I seem unable to trigger a calibration sequence for my Fibaro Roller Shutter 1 (FGR221 v2.1). The manual states the only possible way to trigger a calibration is to reset the unit by excluding then including it into the Z-wave network. I tried this several times. For the last try, I also cut the power for 30 seconds before including it again. In the manual I read that, after a succesful include, there should be a calibration sequence. This does not happen. Do you have any suggestions for triggering a calibration?