Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'gen5'.
I bought a Fibaro motion sensor zwave plus. (looks very cool btw I tought your controller has to support that protocol. By trying out that sensor i saw a big improvement in range. None of my devices are reaching that far as the motionsensor does. I tried it out and they all fail to connect to HC but this motionsensor zwaveplus works like a charm at that distance. I've been reading an article from mr. @T.Konopka about the difference between zwaveplus and next Gen5 zwavechip. So..what is the truth behind this ? UPDATE !! So to b
I know the HC2 can include gen5 devices, since they themselves are downwards compatible. But can the HC2 itself act as Z-Wave Plus controller and thereby use all new functions introduced with Z-Wave Plus? Will that be possible with a firmware update for the Z-Wave RF module, that's integrated into the HC2?
Hi, I'm using a Home Center 2 running firmware version 4.032. I recently purchased Aeon Labs Recessed door sensor (gen 5). After adding the sensor to the system it has no parameter template, but it does work during its initial wakeup time. When the sensors exits the wakeup time nothing is communicated back to the system on open/close until it is woken up again. I found the parameters needed online and tried adding them without any success. I've also tried deleting and adding the sensor many times. Is the sensor working for anyone here? Regards flatsurface