Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'hidden'.
I have three RGBW controllers, all operating in input/output mode. Having successfully configured all three, I notice two puzzling facts: 1. All units are configured with one master and six slaves. For two of them, these are numbered from xxx.0 to xxx.5. For one, however, the first slave is numbered xxx.0.1, not xxx.0. 2. I want to "hide" all units except the four output channels (xxx.2 to xxx.5) The first slave unit (xxx.0 or xxx.0.1), however, refuses to save the check mark in the box "This device is hidden in the system". I can tick the box, but after Save the box remains un-ticked. There is no error message. If you have an RGBW controller, please share your observations on either of these issues. You don't have to provide an explanation or solution, just share what you see on your units. Note: The firmware version is 25.25 on two of my units. One was recently updated to 26.0 without affecting the two problems above.
Having installed my first Fibaro Dimmer 2 on the HC2, I noticed that in addition to the main unit, which has a lightbulb icon, one of the slave units was also visible (i.e. not hidden). This unit had the tag X.0.1, where X is the allocated device number. This slave unit was also equipped with an icon, a remote control, but I have no other unit installed than the basic dimmer. Other slave units are hidden as expected. It is not hard to tick off that the X.0.1 unit should be hidden as well, but is rather confusing to have extra units appearing when I am installing only one.
L.S. There are plugins, which are used only once for configuration. After that they are only taking place in gui. Please add the posibility to make plugins hidden in system like the other devices. Thanks for your attention.