Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'jeedom'.
Hello everyone, I just got in my new flat and decided to set-up my domotic apparatus starting from a Yubii Home hub. No issues with dimmers, door/window and smoke sensors. The problem is that my flat was pre-equipped with Somfy RTS shutters and a Danfoss Ally radiator hub (Zigbee protocol), which unfortuantely are not comatible with the Z-Wave protocol. I have been looking around to understand what could be the easiest course of action to controll all devices from my Yubii Home box. From my understanding, either a Jeedom or an Eedomus hub, along with a RFXCom module, should do the trick for both the shutters (hence the RFXCom module) and the radiator hub. As I'm not an expert however, I was hoping that someone here could either confirm the above makes sense or propose an alternative course of action. Thank you in advance for your help!
Dear Sir or Madma, I am new with Domotic and I traing to get the Luminosity of the MultiSensor 6 with Jeedom. Actually my room has the light off and the sensor show me 0 Lux. I switch the light on and the sensor still show me 0 Lux after one hour. I change the Wakeup interval to 300. It means the sensor should show a new luninosity value after 5 minute. Morever, I chage the value of Luminance report Threshold to 5. It means after variation of 5 Lux, a report should be send to my Jeedom controller. I can not be sure, but it look like the report is sent after 15mn instead of 5mn. (I am aware, 5 is not a good idea for the battery life) I would like to solve that problem, in the way that the MultiSensor 6 show a new value as soon as possible, when the luminosity changes. For now I have no solution and my idea is the send a command from the Jeedom controller, to wakeup the sensor, and the to get a report. I do not know whcih would be the best way to get the new value as soon as possible, or as soon the luminance (light) changes. Would you a suggestion to get the goal? Which parameter should I change? which action should I create? Many thank for your help and happy new year!!
Good day all, I am new with Fibaro and domotic. Last week I setup a Jeedom controller and it work fine with a Heat Controller, a light and door sensor. I ordered a KeyFob devise and I success setup the round key to switch on/off the light. However, I have difficultly to understand how to program for a little bit more complex application. I pain to find help with the documentation, as well. I would appreciate of you could give some tips and hints, a tutorial to better understand or if you could help to reach my goal. (I have a jeedom Z-wave controller) The idea is to setup "a menu" with the round key and the square keys. When I pressed once the square key: I would like to increase or decrease the heat with the + and - key After 5 sec, the + and - key are inactive When I pressed once the round key: I would like to increase or decrease the light of my room with the + and - key After 5 sec, the + and - key are inactive When I pressed once the cross key: my flat change to the "bye bye" mode (out the flat) (Heat=> 5°C, lights OFF) When I pressed once the triangle key my flat goes to "Welcome" mode (heat=> 21°C) For now, my main interest, is how to setup the round and square key, to "say" to the + and - keys, on with devise (heat controller or light) they have to make an action. I would like to avoid pressing to keys, as for example, the round and the -, to decrease the light. I guess it would be not possible, as the round and - keys, are to go to the KeyFob menu. Many many many thnak for your help and suggestion. I wish you a nice day. Cheers