Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'menu'.
Good day all, I am new with Fibaro and domotic. Last week I setup a Jeedom controller and it work fine with a Heat Controller, a light and door sensor. I ordered a KeyFob devise and I success setup the round key to switch on/off the light. However, I have difficultly to understand how to program for a little bit more complex application. I pain to find help with the documentation, as well. I would appreciate of you could give some tips and hints, a tutorial to better understand or if you could help to reach my goal. (I have a jeedom Z-wave controller) The idea is to setup "a menu" with the round key and the square keys. When I pressed once the square key: I would like to increase or decrease the heat with the + and - key After 5 sec, the + and - key are inactive When I pressed once the round key: I would like to increase or decrease the light of my room with the + and - key After 5 sec, the + and - key are inactive When I pressed once the cross key: my flat change to the "bye bye" mode (out the flat) (Heat=> 5°C, lights OFF) When I pressed once the triangle key my flat goes to "Welcome" mode (heat=> 21°C) For now, my main interest, is how to setup the round and square key, to "say" to the + and - keys, on with devise (heat controller or light) they have to make an action. I would like to avoid pressing to keys, as for example, the round and the -, to decrease the light. I guess it would be not possible, as the round and - keys, are to go to the KeyFob menu. Many many many thnak for your help and suggestion. I wish you a nice day. Cheers
The keyfob manual v1.1 describes the menu as follows: Menu allows to perform Z-Wave network actions. In order to use the menu: 1. Click CIRCLE and MINUS simultaneously. 2. Click TRIANGLE or CROSS until LED indicates desired menu position with colour: • White - wake up the device • Green - learning mode (adding/removing) • Cyan - check battery level • Yellow - reset the device* 3. Click PLUS to confirm selection, Click MINUS to exit the menu. 4. LED will pulse twice with same colour as selected menu position to confirm completing action. I have followed these instructions, but already at step 2, the LED does not come alive no matter how long I press TRIANGLE or CROSS. Any help is highly appreciated. Cheers