Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'shutter 3'.
Hi all, setting parameter 20 on the FGR-223 to 1 does not seem to have any effect. I use the device with toggle switches. Even with parameter 20 set to 1 movement does not stop when the switch is put back to neutral position but only when any switch is toggled again. In fact the device behaves identical with parameter 20 set to 1 or 0. Setting parameter 20 to 2 on the other hand shows the expected behaviour for a single momentary switch. Did anybody manage to get the FGR-223 work correctly with toggle switches? Thanks Jürgen
Dear all, For over a year I'm working with Fibaro components and all installing easy and working fine. I'm using Fibaro Home Center Lite (HCL) I have Fibaro roller shutter-2 (FGR-222) working perfectly with Dooya-DT52S curtain motor using a double momentary switches. Installation and calibration was literally a 5 minutes job. Last month I bought a Fibaro roller shutter-3 (FGR-223) Including the shutter-3 on the HCL (firmware 4.520) was ok, but the parameters in the advanced-tab where not visible and calibration was not possible and using the connected switches didn't work opening/closing the curtains. (same Dooya-DT52S motor and double momentary switches) I did fully reset the shutter-3 module and excluding more times, accordingly including it again. No succes. Tried this multiple times. Last week new firmware for the HCL was available, firmware 4.530. I installed that one. Accordingly I included the shutter-3. Inclusion was succesfull and yes the parameters where visible on the advanced-tab. Next step I was quite confident with, the calibration. But after trying over multiple times and with different settings, no succes on calibration at all. The advanced tab has a "calibration" button, or you can do it by way of the B-button or the switches. Non of them was getting the curtains getting moved for calibration. I'm 100% sure all is connected (curtain, power, switches) correctly to the shutter-3 module. The curtain motor does respond when pushing the momentary switches (a long push of 2 secs.), but not in a way it should be. I've some doubts on this module. Attached some screenshots showing a couple of parameters of the shutter-2 and shutter-3. The shutter-2 is clear in how to make settings. The shutter-3 is (for me) totally unclear how to set. It's like some hex.dec numbers to enter. Does anyone know this is the correct way of displaying the parameters of the shutter-3? Meanwhile I'm also in contact with my suppliers helpdesk. No solution till now. Made rma request for returning the shutter-3, for refund, replair of change to shutter-2. Not contacted Fibaro directly. Might do later. Anyone advice on this? Thanks. Niels 190901 Shutter V2 en V3 parameters.pdf