Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'singleswitch2'.
I have got a Fibaro single switch 2 built in a switch box. I used to operate it using Domoticz, however that system got corrupted and I was not able to restore the database in a fresh install of Domoticz. Therefor I decided to purchase a Fibaro Home Center 2. The system works like a charm and I also want to add the Single switch 2. To do that I understood I have to reset the module using the following steps: Resetting the device: Switch off the mains voltage (disable the fuse). Remove the Switch 2 from the wall switch box. Switch on the mains voltage. Press and hold the B-button to enter the menu. Wait for the visual LED indicator to glow yellow. Quickly release and click the B-button again. After few seconds the device will be restarted, which is signalled with the red LED indicator colour. I think I followed all the steps: shut down the power, removed the switch from the switchbox and pulled out all the wires from the module. Then attached all the wires again, switched the power back on, pushed the B-button for a few seconds until the yellow led turned on, release the B-button and quickly pushed it again...… only I didn't get a red LED indicator telling me the module was restarted and reset. I cannot find the module when I want to add it to my HC2. What did I do wrong? And more important, what do I need to do to be able to factory reset the module and add it to my HC2? Deleting it from Domoticz is not possible anymore, because that system is crashed end not working anymore. I must do it like the method mentioned above.... only I don't know what I do wrong. Pleas help me out.
I have single switch 2 module and two way wall switches configured as it is shown on the image. The unknown area is where the lights are (in one case I have 2 lights and in one case 6 staircase lights - but this is not relavant). I stated "unknow area" because I am not the one who were wiring this lights (electritions did) so I am not sure how the wires go to and from the lights to the wall switch... I can only open the wall switches and they are wired as you can see on the attachment. So my question is if this is enought information to put the single switch 2 and it will work or I need some wires from or to the light also ... I have tryed to wire it like it is mentioned in instructions: - Put blue wire in N - Identify the Live wire with voltage tester (in my case the black wire was always on - so it is Live) - I have put the black wire then in L on switch - And other wire - brown to Q - L and S1 to wall switch And this wiring has worked for me and I can manipulate with it - but I have one problem with second wall switch... It has to be always turned on, so my circle is working... If I turn of the Switch 2 (wall switch) the circuit was breaken I guess because it stoped working. So my question is if I can manage to fix this thing with the data that I have, or how can I proceed? have I done something wrong? I can say that I have also try to connect the Single switch 2 modul to second switch, but in this case I can't use the switch for turn on/off the lights... I don't have any more ideas for how to fix this. Should the single switch 2 modul always be in specific wall switch, or is it always possible to put it in one or the other wall switch? Thank you for your help!!! Kind regards Jani