Search the Community

Hi everyone, at the moment I have five Shutter in use and in future I will increase quantity to 10 pieces or more. In my smart home solution (z-wave.me) I had more than 20 devices in use, before I added Fibaro devices, and i'am not will changing this. Now I will upgrade to the newest firmware for the roller shutter, but I found no download's for firmware files. This ist a big problem, for a good device, but not using HC or HC2. Where can I download firmware files for Roller Shutter? Regards Lud

I have tested Aeon Labs Minimote and Zwave.me RC2 (Formerly Duwi). Both these remotes get added to HCL but they wont work without LUA. Is there any way to make this work?

Hi there Altough some people are getting the zwave.me keyfob to work, I tried several methods, but it does not seem to activate my scenes. I have the ZME_KFOB2 (Version 1.4*) *With 1.3 you can add the device holding the four buttons for 5 sec. and push then button 3 *With 1.4 you can add the device holding the four buttons for 5 sec. and push then button 1 I just want to start a scene when I leave the house en start another scene when I come home. I included the device and also woke up the device. I also was able to configure the parameters so that I can start a scene with button 1,2,3,4 However when configured the following scene, nothing works. Controller = Fibaro HC2 214 = device ID Keyfob 159 = light scene on 160 = light scene off Scene 1 ------------------------------------------------------------------------------------------------------------------------------------------------------ --[[ %% properties 214 sceneActivation %% globals --]] if ( tonumber(fibaro:getValue(214, "sceneActivation")) == 11) then fibaro:startScene(1); end if ( tonumber(fibaro:getValue(214, "sceneActivation")) == 12) then fibaro:startScene(160); end if ( tonumber(fibaro:getValue(214, "sceneActivation")) == 13) then fibaro:startScene(159); end if ( tonumber(fibaro:getValue(214, "sceneActivation")) == 14) then fibaro:startScene(160); end -------------------------------------------------------------------------------------------------------------------------------------------------------- I also tried the following scene Scene 2 ---------------------------------------------------------------------------------------------------------------------------------------------------------- --[[ %% properties 214 sceneActivation %% globals --]] -- This part makes sure that the script only runs once if (fibaro:countScenes()>1) then fibaro:debug('Kill the second scene!'); fibaro:abort(); end RemoteID = 214; -- Change this number into your remote ID number if ( tonumber(fibaro:getValue(RemoteID, "sceneActivation")) == 11) -- button 1, single press then fibaro:startScene(159); -- Fill in the number of the scene you want to activate end if ( tonumber(fibaro:getValue(RemoteID, "sceneActivation")) == 12) -- button 2, single press then fibaro:startScene(160); -- Fill in the number of the scene you want to activate end -------------------------------------------------------------------------------------------------------------------------------------------------------------------- Any advice? Thanks in advance!