Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
jasedk 7
I am running my HC2 with firmware 3.600. Generally, my system works OK but I sometimes experience a strange issue with one of my motion sensors.
From time to time, the motion sensor is stuck in “breached” mode. My first though was that the motion sensor (an Everspirng SP103) was faulty, so I replaced it with an Aeon Multisensor.
Now I see the same problem with the Aeon Multisensor. The only solution is to reconfigure the sensor and wake it up. Everthing works fine after this but after a couple of days, the problem is back. I have a couple of motion sensors connected to a Fibaro universal binary sensor and these have never had any issues.
Have anyone else had this problem of motion sensors getting stuck in breached mode?
I saw the same issue with HC2 firmware 3.951.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.