Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Entering recovery mode (factory reset)


j.nowacki

Question

Due to numerous requests I decided to describe the recovery procedure for our controllers. Recovery mode allows you to bring controller to out-of-the box state, with the firmware version it was shipped with to you. There is no way to go back to version older that the one you got device with originally.

 

Entering recovery mode on Home Center 2:

 

1. Unplug your device from power.

 

Please login or register to see this attachment.

 

2. Hold down the recovery button (with a little "+" on it )

 

Please login or register to see this attachment.

 

3. Plug the device back, still holding the recovery button

 

Please login or register to see this attachment.

 

4. Release button as soon as diodes start to blink from left to right (opposite direction as usually during boot up), enter device configuration page, it should look like this:

 

Please login or register to see this attachment.

 

 

Entering recovery mode on Home Center Lite:

 

Procedure is the same as in Home Center 2, only difference is that diodes blink in different manner, but you still need to release recovery button as soon as they start to light up.

 

 

 

Holding recovery button for too long may cause controller to enter static IP mode. In that case one can attach it to computer directly with RJ45 connector, adjust his own network settings (IP in the same pool and default gateway 192.168.81.1) and perform recovery this way.

  • Like 1
Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Guest
This topic is now closed to further replies.
×
×
  • Create New...