Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
Guest Kuuno
I ran into a situation where whole zwane network hung. there are about 100 devices.
the problem does not come from HC2 (i turn it off and problem persists)
i can tell it with special 868mhz analyser. it shows how much traffic is in that range.
normally its led indicators are off and when I turn on light then it shows signal for 0.5 sec while eg dimmer sends on/off command to controller
in my case majority of the modules show constantly 100% signal on the indicator scale. there is something being transmitted all the time and probably over routing it gets everywhere...
how to debug this?
i started turning off fuses but did not get to the cause yet. this seems possible way to me
any experiences in such cases?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.