Set indicator function

[lurendrejer 0]

Hi.

 

I'm using ZCH5010 light switches throughout the house.

Having the "indicator set" command would greatly improve their usability. For instance, settings indicator 4 on when the garage door is breached.

 

What is planned regarding the indicator commands?

[T.Konopka 8]

On 9.04.2017 at 7:23 PM, lurendrejer said:

I'm using ZCH5010 light switches throughout the house.

Having the "indicator set" command would greatly improve their usability. For instance, settings indicator 4 on when the garage door is breached.

Hello,

I apologize but I do not entirely understand your suggestion. Please, elaborate on this.

[lurendrejer 0]

Hi

 

The front panel of the light switches has four indicators (leds), which can be controlled by the indicator set class (i'm guessing some default z-wave function). Logicsoft controllers, homeseer and vera devices seem to have this functionality. Using an indicator set command in a scene would make it possible to turn on the LED if the garage door is open, and when pressing the lid switch, it will close.

 

 

For further info, look here:

Please login or register to see this link.

on page 7: (bad formatting, sorry)

 

Indicator Command Class

.

It is possible to control the LED in each logical device by means of sending

Indicator Set

commands with the requested level

to each of the logical devices

. Level 0 turns off the

LED

and

levels

in the range of

1

–

100

gives the percentage of LED

brightness. If

only the Indicator

Command Class must control a LED

, then

the

LED handling

,

in

each of the logical

device

s,

can

be

disabled

by means of configuration parameters #3

-

#6.

Edited April 12, 2017 by lurendrejer