Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Fibaro FGS-223 Power Measurement


fhermes

Question

Hi,

i have bought two FGS-223 Modules because of there Power Measurement capacity. There are currently two devices connected. The devices change there power consumption during Use. My problem is that this does not shown in the power consumption. i should only see the power consumption if i switch it on.

In Example, my lawnmover needs during charge 50W, conservation charge 2,6W and if it is driving 2,4W. If i switch the power on, the system shows me 2,6W all day, even if it is chargeching. Other Example are my pumpcontroll... it need during pumping 600W and if its in standby just 10W... . the system shows me all over day just 600W.

I have changed for testing Parameter 50 = 1% , Parameter 51 = 10s , Parameter 53 = 0,01kwh but it does not change anything.

 

Where is my fault? Does anyone should have the same issue ?

 

Thanks in Advanced

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

  • 0

Hello,

 

Are you sure that associations are correctly set?

Can you check the first association group? Is multi-channel association set?

Link to comment
Share on other sites

  • 0
  • Inquirer
  • Hi,

     

    it seems to be Multi channel association set with HC2 as Master

     

    Single channel associations
    To be set:
    Current (on device):
    Multi channel associations
    To be set: 1(0)
    Current (on device): 1(0)
    Link to comment
    Share on other sites

    • 0

    Hello,

     

    The 1 association group should be ticked. That's fine.

    What happens if you bring the default settings for the parameters?

    Link to comment
    Share on other sites

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.

    Guest
    Answer this question...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

    ×
    ×
    • Create New...