MCO Home Thermostats reading only 'auto' settings instead of 'manual'
Just so you know, MCO Home Thermostats in version 2.4 (MCOEMH7-EH) are not working in Fibaro currently.
You can change the temperature and basically use it someway, but Fibaro reads out the MCO "auto" mode settings and shows it in the system even though the thermostat is set to manual. After that, the info in HC is not real and it does not reflect current settings on thermostat.
It can be used if you every time swich in Fibaro to "heat" and then set the temperature, but after some tim
For MH7-EH / MH7-WH (Z-Wave versions) and MH7-EH-WT15 / MH7-WH-WT15 (Z-Wave plus versions with integrated humidity sensor and w or w/o ext. temp sensor)
Manual Mode (that means controlled by Fibaro Temp Profile) is on UI:
- third slave -> heat
- first slave -> heating
Automatic Mode (that means controlled by MCO Home Thermostat stored profile) is on UI:
- third slave -> energy save heat
- first slave -> energy save heating
Away mode w
