I installed last week a door sensor and the door status reporting is from time to time incorrect.
It is ok for a couple of cycles and then it get blocked on the open or closed status.
After some time it get back to normal.
Not sure what the problem is: bad contact with HC2 software 4.14 (sensor and HC2 are place in opposite corners of my house roughly 15m with 2 walls in between, any way to test connectivity?) ,
installation ? ( according spec max 5 mm which it is close to
Thank you. That is very useful information.
Unfortunately I still have to speculate a bit but if you do not mind that, here we go!
The "backbone" of your network is 6xFGS223 and 1x FGBS and 2x FGWP because they can pass messages. Not too bad, but maybe their not in the most optimal location. Maybe your sensor is still in a dead spot.
Here is a somewhat generalised sketch of why that could happen:
Please login or register to see this attachment.
Nod