I am trying to connect my HC2 to my alarm installation (jablotron 100) by means of the jablotron module JA118N and the fibaro binairy sensor
based on attached documentation i found on the credex website.
It works but it is unrealiable. Status do not get updated all the time.
I first believed that there was an issue with the communication between sensor and HC2. Just to make sure i added a FGS223 in the same room
to take advantage of the mesh network. I did a network re
OK, but the PCB is copper and grounded...
The UBS might pick up noise from the PCB
So you expect the UBS to pick this FGS as a router. It does not work that way. The UBS stores a list of neigbours it can talk to. An undisclosed algorithm first tries to send to the controller, then a neighbour. It does not try "the best" and it does not try indefinitely either. Going by my personal experience with these older devices, it is better to have "no direct connection to the co