Heating overide

[Derek1948 1]

I have my heating panel set up to control the timing of 4 zones. Each zone has a SRT321 themostat connected to Fibaro relays which switch electric heaters. The timing from the heating panel works perfectly. Also, if I need to deviate from that pattern I can successfully do that through the heating panel manual setup (e.g. change the setting to 18⁰ for 3 hours.

I can also physically change the thermostat to alter the set temperature for a chosen number of hours. All fine.

However, if I change the temperature up on the HCL interface, although the message is successfully sent to the thermostats, the relay switches on for only a brief period (seconds) then reverts to off.

This is becomes a real problem if I want to change the temperature 'at a distance', e.g. through the android app.

What do you think is happening?

[ryvaenge 5]

Is it just the "zones" button you have missed in the android app?

Press Climate and you have a "zones" selection. There you have the same "manual mode" as you have in heating panel.

If I understood you correctly?

[Derek1948 1]

Thank you for that. Silly me! One of my devices has not been updated to 1.18 so 'zones' doesn't show, but the other one does. i shall have to update.

Thanks!

 

Problem solved!