Inlcuding Philio PSP05

[Alex 31]

Does anybody else have a "Philio PSP05" outdoor motion sensor and did it get working?

After a couple of tries I got it included successfully (and if I press the intern wakeup button I can see the it is updating the status).

But there is no motion registered. The sensor itself blinks red while registering motion and in the Fibaro Logs I can see that z-Wave chip does get know of this state change.

But the motion event is not triggered at all.

 

Please login or register to see this code.

 

[timppa 1]

I have the same issue. Fibaro support replied that it has to be associated to group1 with the home center. However this never seems to go through. 

I have tried several times. 

[timppa 1]

Maybe the issue is that the device is sending motion detect as "Notification Report" and not in Binary. Parameter 7 needs have bit 4 set to 1 (1d 16) to enable binary mode.

However I'm having difficulties on enabling this as it always defaults to 4.

 

 

[net 8]

Same problem here.

Any suggestions from Fibaro?

 

[mirage1981 0]

Hello,

has anyone been successful with the sensor yet?
I have successfully added it to the network and it detects movement. So I can switch on the light via a scene.
But the automatic OFF is missing, the sensor stays on until I press the temper or the inner button.
Unfortunately I was not successful to change the parameter 7 ... it is unfortunately always 4 

[alireza44907 0]

Hello,

watch this video to get the sensor working flowlessly:

https://m.youtube.com/watch?v=e-U4UIeqMlU