Linked devices

[jack.daniels 103]

Hi, 

I have a humidity device connected by the fibaro wall plug and a sensor.

I have linked it inside the linked devices panel but it seems there is no effect. The wall plug does not change its state nevermind how big/low the sensor value.

I tried the week schedule, manual and holiday mode as well.

 

Any info regarding how the linked devices works available?

 

May be there is some solution for such cases? Just a manual target value selection with a slider is enough  

Ty

[I.Srodka 4]

Hi @jack.daniels!

 

What thresholds did you set?

 

When should the Wall Plug act?

 

Could you post some screenshots?

[jack.daniels 103]

19 minutes ago, I.Srodka said:

What thresholds did you set?

 

When should the Wall Plug act?

 

If you mean the sensor mesurements report thresholds - its default value for AEON Multisensor 6.

The wall plug should be ON when current mesurements < target

What screenshots you need to see? Humidity panel? 

 

[I.Srodka 4]

23 minutes ago, jack.daniels said:

The wall plug should be ON when current mesurements < target

Which part of the system tells you it is set up this way?

[jack.daniels 103]

48 minutes ago, I.Srodka said:

Which part of the system tells you it is set up this way?

I expect You to tell me

The Fibaro manual says: Link devices and shedule in Humidity panel.

 

[I.Srodka 4]

Okay, so in that case you should start by reading this article:

 

Please login or register to see this link.

 

 

 

[jack.daniels 103]

19 minutes ago, I.Srodka said:

Okay, so in that case you should start by reading this article:

 

Please login or register to see this link.

 

 

 

This is the one I mention before. It says just link 2 devices. No more settings available. Tell me what to do next, please

[jack.daniels 103]

HCL 4.150:

Please login or register to see this attachment.

[I.Srodka 4]

Okay, but then you need to set up the zone and a schedule:

Please login or register to see this attachment.

 

Please login or register to see this attachment.

[jack.daniels 103]

Solved, thanks

The problem was: zones were created, but no room assigned for each zone. Need to add this step to the manual.