Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
Emphyrio 0
I seem unable to trigger a calibration sequence for my Fibaro Roller Shutter 1 (FGR221 v2.1). The manual states the only possible way to trigger a calibration is to reset the unit by excluding then including it into the Z-wave network.
I tried this several times. For the last try, I also cut the power for 30 seconds before including it again. In the manual I read that, after a succesful include, there should be a calibration sequence. This does not happen.
Do you have any suggestions for triggering a calibration?
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.