Fibaro UBS strange behaviour???

[morpheus75 75]

hi

this has been happening for a while and i cannot explain it. it has started after the 4.170 update so dont know if its related?

i have about 9 UBS which all have been working perfectly fine for a while and only 1 has temp sensors.

i have noticed that since the last 4.170 update i am getting intermittent notifications that the sensors are being breached. sometimes they work and other times the dont.

there is no pattern and i believe that my mesh network is pretty good and stable as no issues with other devices. (i have a fair few scattered around the house).

anyone else experienced this issue??

thanks

 

[Jamie mccrostie 82]

4 minutes ago, morpheus75 said:

hi

this has been happening for a while and i cannot explain it. it has started after the 4.170 update so dont know if its related?

i have about 9 UBS which all have been working perfectly fine for a while and only 1 has temp sensors.

i have noticed that since the last 4.170 update i am getting intermittent notifications that the sensors are being breached. sometimes they work and other times the dont.

there is no pattern and i believe that my mesh network is pretty good and stable as no issues with other devices. (i have a fair few scattered around the house).

anyone else experienced this issue??

thanks

 

Yes same issue Multiple Ubs

used as alarm pir indication

freezing on breached condition

sometimes clearing after .5 hr

sometimes requiring power off

seems to effect 2 of 5 

[Momos 101]

Up to FW 4.140 all my UBS devices were working fine - 6 of them.  Since upgrading to 4.160 i started to have network delays, LUA latency and occasional dead nodes.  I excluded all my UBS devices and network is fine since then.  I was using these UBS devices for 2 years with no issue, now they just sit in my drawer