Aeotec Range extender

[Jamie mccrostie 82]

Always when I include the Aeotec

range extender it stays unconfigured .

Any ideas?

 

Edited May 25, 2018 by Jamie mccrostie

[nmsolaris 0]

I have exactly the same problem, Not even sure the extender is working.

[FonsBrand 6]

MeToo, I dont see anny improvement with far Nodes, they reporting still as dead nodes.

[Jamie mccrostie 82]

2 hours ago, FonsBrand said:

MeToo, I dont see anny improvement with far Nodes, they reporting still as dead nodes.

Have you reconfigured mesh network?

[FonsBrand 6]

7 hours ago, Jamie mccrostie said:

Have you reconfigured mesh network?

 how do I do that

[FonsBrand 6]

30 minutes ago, FonsBrand said:

 how do I do that

Found it, but do I do an entire z-wave reconfiguration or only on the "range extender" and the remote nodes?

[Jamie mccrostie 82]

Do entire because its the dead modules neighbors as well as booster you want remeshed

[FonsBrand 6]

OK, I did do an entire z-wave reconfiguration and I know that it would take a long time to complete, so I left my laptop open and left it.

When I came back two hours later the session was crashed by an script timeout and I don know if the process is completed.

I have to test if there are improvements or not.

[FonsBrand 6]

I have done some tests and it seems to be beter responsive.

Thanks for pointing me out.

[[email protected] 0]

Aeotec range extender is not adding to fibaro HC. Please advise 

[Jamie mccrostie 82]

It says unconfigured but still seems to work ok.

There are no user changable settings anyway.

[Al3x 2]

Device appears in mine as unconfigured but works.