Heat Controller problem with temperature resuming

[marcinsz 2]

Hi Fibaro. I am using the Heat Controler with Homekit automation for some time now. No major problems with exception to frequent calibrations (which you need to address by the way).

 

My issue is that whenever the Controller starts its cycle of descaling or calibration or whatever it is doing (engine works loudly for a couple of seconds), it doesn’t resume the temperature setting it had before. It sets itself to 20 degrees Celsious. I have to set the temperature back to its previous setup manually from automation again.

 

My mode is set to manual and hold. The temparature is set by automation. My hub is atv4k.

 

Could you please help with this?

 

 

 

Edited December 5, 2018 by marcinsz

[marcinsz 2]

Really. Nobody?

 

Noticed one more thing. Calibration disables holiday mode and turns on schedule. This shouldn’t work like this?

[Jaro8038 0]

Hi. I had the same problem in two heads. Please reset the head and it will work properly. For me after the reset they work properly.

[marcinsz 2]

I have reset today. I will share if this was successful

 

 

18.12.2018 update

It still doesn't hold settings...

Edited December 18, 2018 by marcinsz

[marcinsz 2]

I have contacted Fibaro. They say my issues are common and addressed in the upcoming update. Eta early Jan’19

[marcinsz 2]

When is the update coming out?

[xmanteam 0]

Never

Never