Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
knuth 29
I have three RGBW controllers, all operating in input/output mode. Having successfully configured all three, I notice two puzzling facts:
1. All units are configured with one master and six slaves. For two of them, these are numbered from xxx.0 to xxx.5. For one, however, the first slave is numbered xxx.0.1, not xxx.0.
2. I want to "hide" all units except the four output channels (xxx.2 to xxx.5) The first slave unit (xxx.0 or xxx.0.1), however, refuses to save the check mark in the box "This device is hidden in the system". I can tick the box, but after Save the box remains un-ticked. There is no error message.
If you have an RGBW controller, please share your observations on either of these issues. You don't have to provide an explanation or solution, just share what you see on your units.
Note: The firmware version is 25.25 on two of my units. One was recently updated to 26.0 without affecting the two problems above.
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.