Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
Mosskit 4
Hi guys,
I have all my venetian blinders controlled with RS2 but without S1/S2 connected to a switch. This is all done by scenes/phone or switches installed elswere (so all remotely controlled). What I like most is actually controlling an angle of lamelas. It takes around 0.8 seconds to toggle lamellas fully from one side to another (so around 0.4 sec from closed to opened position allowing sun go through). I was trying to play with associations and multilevel value but all it does is it allows to set a height position of blinders. I found best result with angle setpoint is when I always make a close cycle and then set lamelas level what is easily built with a scene but.. when there is no HC2 for some reason I am stucked. I wonder if there is any way to overcome this, maybe with 3rd party switch or a remote controller? Any ideas or experience here?
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.