Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
mirekmal 0
Hello there! Recently purchased 3 pcs of Smart Impants to use them in my home automation (based on home assistant -- hassio). I added all devices succesfully to z-wave network, but strangely these seems to be appear differently. One device behavies as expected, exposing to hassio 17 entities (in hassio entity is 'property' of device, like switch, analog sensor, binary sensor, temperature sensor etc). Most important I can see 2 pairs of binary inputs and outputs (IN1, OUT1, IN2, OUT2) that I need. On the other 2 devices I can only see less than half of this setup - only 7 entities. No IN2, Out2 no entities for analog inputs. I tried to remove/add again, reset devices to factory settings, heal the network or nodes, clear config cache etc, but no change. As I recall for these 2 devices it was like that from the beginning (well, these were my first implants, and I was just playing with setting configuration parameters, so I was afraid that Iscreewed something there). Any idea? Are devices faulty? Anybody faced similar issue? Any recovery method? Otherwise it would not be a good quality/reliability sign to have 66% of devices out of order...
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.