Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
t3chris 0
Hello!
My S1 input is connected to a non-z-wave motion sensor and an auto-off timer is configured. Whenever the motion sensor is triggered, the load on my Dimmer 2 turns on. That is fine, however, at the next motion event, the load turns off.
I would want to configure the Dimmer so that it only reacts on "Power-On" events through S1, if it is powered on already and S1 is triggered, then it should ignore the command, ideally, it should just prolong the load's timeout.
Is that possible?
Thanks,
Christian
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.