Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
knuth 28
I have three RGBW controllers. Two of them have been successfully updated to firmware version 27.27. The third refuses to do so. Download of the new version 27.27 is OK, but about half way through the installation it fails: Status: fail - update interrupted - device connection lost. try again.. This happens consistently, in spite of the fact that this controller is installed less than a meter away from the HC2. It may or may not be relevant, but I noticed today that during the update, the following message kept coming up:
Please login or register to see this image.
/monthly_2019_08/image.png.2ba79b8c8c4fe41f234bbab1e48ad6d3.png" />The last two lines were repeated every 4-5 seconds for several minutes: "set parameter 43, value = 0", and then "Received parameter 43 report, value = 5". My actual value for parameter 43 is the default value of 0.5 V. Why is this parameter changed during the firmware update?
My current fw version on this controller is 25.25
Link to comment
Share on other sites
11 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.