Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
samuelAN 1
Hello!
I just got back my heat controllers updated to last firmware 4.5
I installed them in domoticz. A good news is that even if you don't have external temperature sensor, now the internal valve temperature is listed in the domoticz devices ! (This was not the case before...)
I will test the temperature regulation now...
The issue I have is that polling is necessary in order to get updated values of set point and internal temperature.. and if polling is not enable, the node will be rapidly marked as dead by domoticz! With polling enabled, I am afraid for the battery drain...
Someone has experience to share with this device?
Thanks
Edited by samuelANPut in form
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.