Connect Alarm with 12v output

[rmont 0]

I am trying to connect the smart implant to an alarm with 12v outputs to signal "alarm armed" and "alarm active" (i.e. breach identified).

 

I connected the SI using the inputs as analog. I can see the correct voltage on the analog inputs (i.e. +12v = armed / 0v = unarmed).

 

But I can't make the smart implant to generate events (i.e. open/closed/switched) when the voltage changes. I can only poll the voltage periodically to check if it has changed.

I have already fiddled wit parameters 63 (input threshold) and 64 (periodical report) with no success.

 

What is the right way to generate events when the voltage changes from 0 to 12v?

 

Thanks

 

Roberto

[magicman 9]

hi rmont

Connected to IN1: »Normally close: change parameter 20 to 0»Normally open: change parameter 20 to 1

• Connected to IN2: »Normally close: change parameter 21 to 0»Normally open: change parameter 21 to 1

the answer is by changing parameter 20 for in1 and 21 fo in2