Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
svossepoel 2
Hi,
I have used a Dimmer 2 and Bypass 2 to dim a dimmable led light. The led light uses a very low load. The dimmer device measured 1 W (without own power consumption).
All works fine: switching on and off, dimming. But after a short period (approx. 20 min) the dimmer starts a calibration cycle. After it light returns to original dimming level. After a while, calibration cycle starts again. No notifications and nothing reported.
Any suggestions what is happening here and how to fix it?
Thanks In advance for your expert advice.
Sjaak
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.