Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
CKnoeller 0
Hi there,
I´m pretty new at this and am currently trying to automate my GarageGate (Teckentrup one-button) via Smart implant. I read quite a lot but am facing the following problem: I want to use IN1 for a reed sensor to check whether the gate is open or closed. I wired it against GND and closing the reed is shown in the FHEM event monitor. However, it shows "on" and immediately after "off" although the reed remains closed - I configured IN1 as Bistable button. I obviously do not want any direct relation of that IN1 to any of the two OUTs.
Any input is highly apprechiated. I have to admid that this is true also for the FHEM programming. What I basically want is a "Close gate" event (that only triggers when the Reed on IN1 is open) and the opposite "Open gate" event.
Perspectively I´ll try to add a photoelectric barrier - but not right now. Need to find a bit more of my way into this before adding more complexity...
Thanks!!
Christian
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.