Jump to content

Welcome to Smart Home Forum by FIBARO

Dear Guest,

 

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

 

As a member you can:

  •     Start new topics and reply to others
  •     Follow topics and users to get email updates
  •     Get your own profile page and make new friends
  •     Send personal messages
  •     ... and learn a lot about our system!

 

Regards,

Smart Home Forum by FIBARO Team


  • 0

Heat Controller failure


ivoss
 Share

Question

Hi guys,

I have 7 heat controllers in HC3 at home. Three of seven are gone after few week using. I'm using only two heat schedules per day (morning and evening). Every time when heat controller is gone is: heat controller is fully open (full heating), any response on manual control, any response with control in HC3. Led ring not work, I can't do reset to factory reset (any response on holding button). Device looks like good in HC3, but nothing doing.

Any ideas? Today was third dead :(

Thanks

Edited by ivoss
Link to comment
Share on other sites

2 answers to this question

Recommended Posts

  • 0

The battery of the "dead" heat controllers might be totally depleted. Have you tried recharging them?

There is known problem with the current firmware that sometimes (!) for some reason a heat controller drains its battery completely in a very short time.

If this is indeed the problem you are having, version 4.9 of the firmware was supposed to fix this, but it was faulty and was pulled again, so it can not (yet) be downloaded.

Still, three valves after one week of use is unusual, so maybe it's another issue...

Link to comment
Share on other sites

  • 0

Similar problem here.

I have 3 TRVs with firmware 4.5 which work reliably, but the one with version 4.6 is going nuts occasionally, showing the same behaviour, cannot be controlled, neither manually nor via gateway.

After re-calibrating it, it works fine for about one week until it starts all over again, waking me up with about 23°C in my bedroom.

Using Hubitat Elevation as a Z/IP-Gateway.

What firmware version has yours?

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...